Murata Manufacturing is addressing one of the biggest challenges in modern high-voltage power electronics keeping fast-switching noise from frying sensitive control circuits with its new MGJ2T2 series of isolated gate-drive DC-DC converters.

Built specifically for high-voltage silicon carbide (SiC) power applications, the 2W converters target demanding sectors like EV charging, motor drives, microgrids, and battery energy storage systems (BESS).
The new isolated gate-drive DC-DC converters are also aimed squarely at emerging solid-state transformer (SST) architectures, which rely on high-frequency conversion and cascaded switching stages that each demand clean, isolated gate-drive power.
Taming SiC Switching Noise
Because SiC devices switch at blistering speeds, they create rapid voltage swings that can easily push electrical noise across the barrier separating the power stage from low-voltage control electronics.
Murata engineered the MGJ2T2 series to keep those two worlds cleanly divided:
- High Noise Immunity: It boasts a common-mode transient immunity (CMTI) exceeding 200kV/µs to ride out sharp voltage spikes.
- Ultra-Low Capacitance: Isolation capacitance is kept down to just 2.5pF, choking off noise coupling across the barrier.
- Tailored Gate Rails: Running off a 24V input, the unit delivers +18V/-3V bipolar outputs giving SiC MOSFET gate drivers the punch they need to turn on cleanly and the negative bias required for reliable turn-off.
Inside the Block-Coil Design
To hit these specs without bulking up the footprint, Murata leaned on its proprietary Block-Coil technology. By winding separate coils onto solid insulating formers, the design physically separates primary and secondary circuits while slashing parasitic capacitance.
That physical layout delivers more than 8mm of creepage and clearance alongside high partial-discharge tolerance.
On the safety front, the converters are built to meet UL 60664-1 standards, supporting reinforced insulation up to 800Vrms (or basic insulation up to 1600Vrms) and withstanding 6kVDC test voltages with 8kVDC isolation rated across the series.






